WhisperKool Extreme 8000 - Manual (Page 14)

Page 14 PT-EXPL 072010
Mounting Flange Pieces
There are four individual pieces located in Kit 2 of your enclosed accessory kits. These flange pieces are de-
signed to be used on the backside of the Extreme Series to mount to the exterior wall. There are three punch-
outs located on the exterior of the housing. The punch-outs are designed for specific through-the-wall installa-
tion mounts. Please refer to the illustration for location of the punch-outs.
#1. Retrofit your current WhisperKOOL
cooling unit
#2. Middle wall installation
#3. Flush mount to exterior wall
THROUGH-THE-WALL INSTALLATION (without ductwork)
Applying Insulation Tape
Locate the four precut pieces of
black foam tape included with the
system. There should be two larger
pieces and two smaller pieces. Once
you have attached the flange pieces
to the unit, peel back the white-
paper adhesive covering and place
on the corresponding size of flange.
The large pieces are applied to the
top and bottom of the unit and the
smaller pieces to the right and left
side flanges. This foam creates a
tight seal between the flange and
the wall.
Front of unit
Back of unit