Step 4 - install storage tank – Whirlpool WHER25 User Manual
Page 11
11
FIG. 12
Step 4 - Install Storage Tank
The fitting on the supply tank may need to be tightened
7-8 turns to get a good seal.
Do not overtighten.
INSTALL STORAGE TANK
1. Apply thread sealing tape to the threads on the nipple
at the top of the tank. See Fig 12.
2. Locate the tubing connector. See Fig. 12. Tighten the
tubing connector with a wrench onto the tank nipple 7-
8 turns, being careful not to cross thread or overtight-
en.
3. Do not connect the tube at this time. This will occur
later in the assembly.
4. Place the storage tank next to the Reverse Osmosis
Assembly. The tank can be placed upright or on its
side.
Storage Tank
Tubing Connector
Tank Nipple
Questions? Visit www.ecodyne.org or call Toll Free 1-866-986-3223
Tubing Insert
Tubing Nut