Weider WESY38320 - Manual (Page 8)

8
7. Press a 2” x 3” Inner Cap (58) into the top of the
Squat Upright (4). Slide the Squat Upright onto the
two indicated 5/16” x 2 1/2” Carriage Bolts (110) in
the Long Base (120). Finger tighten a 5/16” Nylon
Locknut (86) onto each Carriage Bolt.
Do not tight-
en the Nylon Locknuts yet.
Press a 2” x 3” Inner Cap (58) into the top of the
VKR Upright (5). Slide the VKR Upright onto the
two indicated 5/16” x 2 1/2” Carriage Bolts (110) in
the Long Base (120). Finger tighten a 5/16” Nylon
Locknut (86) onto each Carriage Bolt.
Do not tight-
en the Nylon Locknuts yet.
7
8
39
39
39
39
90
115
90
90
90
90
90
86
38
86
86
115
115
115
90
90
94
94
38
39
4
58
58
5
4
120 86
86
110
110
8. Locate the four slotted holes in the brackets on the
Squat Slider (38). Attach a Roller (39) and two 5/16”
Washers (90) between each pair of slotted holes
with a 5/16” x 3 1/2” Bolt (94), two
5/16” Lock
Washers (115), and a 5/16” Nylon Locknut (86) as
shown.
Do not tighten the Nylon Locknuts yet.
Next, attach a Roller (39) and two 5/16” Washers
(90) between each pair of
small round holes with
a 5/16” x 3 1/2” Bolt (94), two 5/16” Washers (90),
and a 5/16” Nylon Locknut (86) as shown. Do not
tighten the Nylon Locknuts yet.
See the inset drawing. Slide the Squat Slider (38)
down onto the Squat Upright (4). Push the two indi-
cated Rollers (39) against the Squat Upright.
Tighten all of the 5/16” Nylon Locknuts (86)
used in this step.