VTech 9127 - Manual (Page 6)

6
The Handset of your 9127 is powered by a rechargeable battery pack. It charges
automatically whenever the Handset is in the Base Unit. The battery pack needs charging
when:
• The low battery icon and message are displayed:
• A double beep is generated.
To charge the battery pack, place the Handset in the Base Unit. The IN USE/CHARGING
indicator will light to show the Handset is seated properly and the battery pack is charging. It
is recommended that the battery pack should be charged for at least 16 hours initially.
Afterwards, 8 hours of maintenance charging should be sufficient.
To install (or replace) the battery pack, follow the steps below:
1. Remove the battery case cover by pressing on the ridged lines and sliding downward.
2. Discard the old battery pack by pulling firmly on the battery cords. Don’t put the old
battery pack in a trash compactor or a fire - it could burst. Please recycle.
3. Snap in the new battery pack, with the wires in one of the lower corners. Insert the
battery plug into the socket, aligning the two holes in the plug with the socket pins.
4. Replace the battery case cover by sliding the cover
upwards.
5. Place the Handset in the cradle of the Base Unit to allow
it to charge for 16 hours.
CAUTION: To Reduce the Risk of Fire or Injury, Read and
Follow these Instructions:
IMPORTANT:
Do not dispose of this battery pack into household garbage. For
information on recycling or proper disposal, consult your local
solid waste collection or disposal organization.
1. Use only VTech rechargeable battery pack, or equivalent.
2. Do not dispose of the battery pack in a fire. The cell may
explode.
3. Do not open or mutilate the battery pack. Released
electrolyte is corrosive and may cause damage to the eyes
or skin. It may be toxic if swallowed.
4. Exercise care in handling batteries in order not to short the
battery with conducting materials such as rings, bracelets,
and keys. The battery pack or conductor may overheat
and cause burns.
To purchase replacement battery packs, call VTech at 1-800-595-9511. In
Canada, call 1-800-267-7377.
INSTALLATION OF BATTERY PACK IN HANDSET
GETTING ST
ARTED