VTech 9127 - Manual (Page 25)

25
ADDITIONAL
INFORMA
TION
FCC, ACTA AND IC REGULATIONS
This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules
for the United States. It also complies with regulations RSS210 and CS-03 of Industry and Science
Canada. Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
A label is located on the underside of the Base Unit containing either the FCC registration number
and Ringer Equivalence Number (REN) or the IC registration number and Load Number. You
must, upon request, provide this information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids.
Should you experience trouble with this telephone equipment, please contact:
VTech Communications Inc
CUSTOMER SERVICE, at 1-800-595-9511. In Canada, call VTECH Telecommunications
at 1-800-267-7377.
For repair/warranty information, the telephone company may ask you to disconnect this
equipment from the line network until the problem has been corrected.
FCC Part 15
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The equipment has been tested and found to comply with part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications.However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Part 68 and ACTA
If this equipment was approved for connection to the telephone network prior to July 23, 2001, it
complies with Part 68 of the Federal Communications Commission (FCC) rules. If the equipment
was approved after that date, it complies with the Part 68 rules and with Technical Requirements
for Connection of Equipment to the Telephone Network adopted by the Administrative Council for
Terminal Attachments (ACTA). We are required to provide you with the following information.
1. Product identifier and REN information
The label on the back or bottom of this equipment contains, among other things, an
identifier indicating product approval and the Ringer Equivalence Number (REN). This
information must be provided to your local telephone company upon request. For
equipment approved prior to July 23, 2001, the product identifier is preceded by the
phrase “FCC Reg No.” and the REN is listed separately. For equipment approved after that
date, the product identifier is preceded by “US” and a colon (:), and the REN is encoded in
the product identifier without a decimal point as the sixth and seventh characters following
the colon. For example, the product identifier US:AAAEQ03T123XYZ would indicate an
REN of 0.3.
The REN is used to determine how many devices you may connect to your tele
phone line
and still have them ring when you are called. In most, but not all areas, the sum of all RENs