Velocity Micro MS-3 - Manual (Page 20)

Chapter 1: Introduction
Microscan MS-3 Laser Scanner Device Driver User Guide
16
Setting the properties for a device
About this topic The device properties provide VWorks or BenchWorks software with
additional information about the device’s current configuration, such as
which profile to use, and stores the information in the device file. The
device file is automatically loaded when you open a protocol.
The device properties need to be set when configuring the device.
Typically, these properties only need to be set once. This topic describes
how to set the following device properties:
❑
General
❑
Teachpoint
❑
Barcode
❑
Location (for devices with multiple teachpoints)
❑
Device Properties
Read this topic if you are an administrator in charge of managing
Velocity11 devices.
Before you start Make sure that you have installed the device driver plug-in and have
added the device to the device manager.
See “Related information” for procedures on how to do these tasks.
Setting general
properties To set the general properties for a device:
1. Click the Device Manager tab.
2. Select the device from the Device List toolbar. (Expand the device
name, if necessary.)
Note: For devices with Locations, see “Setting location properties”
on page 17. If no Locations, continue with step 3.
3. In the General group, set the following:
a. Approach height. This is the height to raise the robot gripper
above the teachpoint when the robot moves the plate
horizontally towards or away from it.
b. Allowed/prohibited labware. Click the adjacent field to open the
dialog box. Move the labware classes by selecting them and
clicking one of the arrow buttons.
4. In the Device Properties, select the desired profile if it is not already
selected.
5. Select File > Device File > Save to save the changes to the device file.