Viper 700 ESP - Manual (Page 19)

18
© 2000 Directed Electronics, Inc.
Power Saver Mode
Your system will automatically enter Power Saver Mode while
armed or in Valet Mode, after a period of time in which no opera-
tion has been performed. This lowers the current draw to prevent
the system from draining the vehicle’s battery. Power Saver Mode
takes over under the following conditions:
■ Power Saver when the system is armed: After the system has
been armed for 24 hours, the LED will flash at half its normal
rate, decreasing the system's current draw.
■ Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a period of one hour while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.
Programming Options
Programming options control what your system does during normal
operation, and require few or no additional parts. However, some
may require additional installation labor.
The following is a list of the program settings, with the factory
settings in bold: