Viper 700 ESP User Manual

Page 13

2000 Directed Electronics, Inc.

Valet

Mode. You must also know where the Valet

switch is

located. Be sure to check with your installer at the time of instal-

lation for the location of the Valet

switch.

To enter or exit Valet® Mode with the Valet switch:

1. Turn the ignition on.

2. Turn the ignition off.

3. Press and release the Valet

switch within 10 seconds.

The status LED will light solidly if you have entered Valet Mode,

and it will go out if you have exited Valet Mode.

You may also enter or exit Valet Mode using your remote.

Remember, the system must be disarmed in order to enter Valet

Mode. The operations described in this section refer to transmitter

buttons. These buttons correspond to a Standard Configuration

transmitter. This may not be how your transmitter is set up.

Open any vehicle door.

Press .

Press again.

The status LED will light solidly if you have entered Valet Mode,

and it will go out if you have exited Valet Mode.

Remote Valet

DRW-35