Lighting grill, Caution – Viking F20455A User Manual

Page 7

tio

Lighting Grill

Lighting TruSear™ Infrared Burner (If Applicable)

Before lighting the burner, remove the stainless steel cover.
Push in and turn the TruSear™ infrared control knob until the
“HIGH” position on the knob aligns with the indicator line on
the control panel, and continue to hold in the knob. Press the
electronic ignition button that corresponds to the control
knob. You will hear a clicking sound. After the burner lights,
hold in the control knob about 5 seconds longer or until the
burner remains lit. Once lit, turn the control knob to the
desired setting. If the burner does not light within 4
seconds, release and turn the control knob to “OFF.” Wait
5 minutes for any accumulated gas to dissipate and try
again. After several failed attempts the burner can be lit with
a paper book match using the flash tubes.

Lighting Side Burners and 24” Wide Rangetop

First, remove the burner cover or any cooking utensil from the
burner grate.

Push and turn the control knob until the “HIGH” position
aligns with the indicator line on the control panel.
Immediately press the electronic ignition button
corresponding to the burner(s) being lit until the burner is
lit or until 4 seconds pass. If the burner does not light
after several attempts, wait five minutes to allow any
accumulated gas to dissipate. If the burner will not light after
several attempts, then the burner can be lit by holding a lit
match next to the burner ports. Push and turn the control
knob until the “HIGH” position on the knob aligns with the
indicator line on the control panel.

CAUTION

The side burner cover may be hot if the grill burners are in
operation.

Lighting Grill

T-Series Models

When lighting a burner, always pay close attention to what
you are doing. Be certain you are pressing the battery
ignition button (T-Series only) corresponding to the burner
you are lighting.

Lighting Grill Burners

Open the hood or remove covers. Push and turn the control
knob until the “HIGH” position on the knob aligns with the
indicator line on the control panel and continue to hold in the
knob. Press the electronic ignition button corresponding to
the burner being lit. You will hear a clicking sound. After the
burner lights, hold in the control knob about 5 seconds longer
or until the burner remains lit. Turn the control knob to the
desired setting. If the burner does not light in 4 seconds,
turn the knob to “OFF” and wait 5 minutes before trying
again. This will allow accumulated gas to dissipate. After
several failed attempts the burner can be lit with a paper
book match using the flash tubes.
If you have just attempted to light the burner with the ignitor,
allow 5 minutes for any accumulated gas to dissipate.

Electronic
ignitor

Side burner
control knob

NOTE: Control locations
will vary according to model.

Grill burner
control knob

Rotisserie
control knob

Flash tube

Place the lit match through the grid next to the flash tube of
the burner being lit. Keep your face as far away from the grill
as possible. Make sure the match is adjacent to the flash tube.
Push and turn the control knob until the “HIGH” position on
the knob aligns with the indicator line on the control panel.
Make sure you are turning the control knob that corresponds
with the burner being lit. If the burner does not light in 4
seconds, turn the knob to “OFF,” wait 5 minutes, and try
again. If the burner will not light after several attempts, see
the Troubleshooting section.