Vanguard Heating VDDVF36STN/STP - Manual (Page 22)

22 106918
DIRECT-VENT GAS FIREPLACE
VDDVF36PN/PP and VDDVF36STN/STP Series
®
1. After lighting, let pilot flame burn for
about one minute. Turn control knob
to ON position. Adjust flame adjust-
ment knob anywhere between HI and
LO. Slide the selector switch to the
REMOTE position.
Note: The burn-
ers may light if hand-held remote ON
button was on when selector switch
was last turned off. You can now turn
the burners on and off with the hand-
held remote control unit.
IMPORTANT: Do not leave the se-
lector switch in the REMOTE posi-
tion when the pilot is not lit. This will
drain the battery.
IMPORTANT: Be sure to press the
ON/OFF buttons on the hand-held
remote control unit for up to 3 sec-
onds to assure proper operation.
GHRC Operation:
2a. Press ON/OFF button to turn the
burners on and off. When turning
burners off, the pilot will remain lit.
ON
OFF
REMOTE
O
FF
PILO
T
O
N
L O
I H
Figure 52 - Setting the Selector Switch, Control Knob, and Flame Adjustment Knob for
Remote Operation
Selector Switch in Remote Position
(Optional Remote Control)
Control Knob in
On Position
Flame Adjustment Knob
OPERATING
FIREPLACE
Continued
Figure 51 - Pilot
Thermocouple
Pilot Burner Piezo Ignitor
OPTIONAL REMOTE
OPERATION
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See
Lighting
Instructions, column 2.
Note: All remote control accessories must
be purchased separately (see Accessories,
page 28). Follow instructions included
with the remote control.
Thermopile