Viper 160XVL User Manual

Page 18

To turn the rear defogger output ON:

Simultaneously press & release the

buttons

on the remote control.

The lights will flash 3 times.

The rear defogger output will once again activate when the

vehicle is remote started.

NOTE: If the remote start is on the lights will turn off then flash 3-times
before returning to their normal output and the defogger output will
activate as programmed.

The Valet Take-Over feature allows the vehicle to remain running

after the key has been removed from the ignition. This feature is

useful for occasions when you wish to exit and lock the vehicle for

short periods of time, but would like to leave the motor running

and the climate controls on.

To perform Valet Take-Over:

1. Before turning off the engine, press and release

on the

transmitter twice in 3 seconds (or press and release the

optional momentary switch).

2. Turn the ignition key to the OFF position. (The engine will

stay running.)

3. Once the vehicle has started, it will run for the pre-pro-

grammed period of time (12, 24, or 60 minutes) or until a

shutdown input is triggered.

Valet Take-Over