Viking TMC 148 - Manual (Page 16)

16
Switching between the memory
banks (FM)
You can switch between the memory banks
I, II and T in order to store stations and re-
call them later.
The currently selected memory bank will
appear in the display.
•
Press BND as many times as neces-
sary until the desired memory bank li-
ghts up in the display.
Storing stations
On FM, you can store five stations on the
station selection keys 1, 2, 3, 4, 5, for each
of the memory banks (I, II, T).
On MW/LW, you can also store five stati-
ons each.
•
Select the appropriate waveband by
pressing BND.
• Tune into a station with the rocker
switch (either automatically / or
manually << >>).
• Press the desired station selection key
until the radio resumes play after the
muting (approx. 2 seconds) or until you
hear a beep.
Now the station has been stored.
The display will indicate which station sel-
ection key is currently activated.
Note:
If you attempt to store a station which has
already been stored, the corresponding sta-
tion key and the memory bank will flash in
the display if you are on a different memory
bank.
Automatically storing the
stations with the strongest
reception with Travelstore
You can automatically store the five FM sta-
tions with the most powerful signals in your
current reception area sorted according to
their signal strength. This function is parti-
cularly convenient on longer trips.
•
Press BND for 2 seconds.
“T-STORE” will appear in the display.
The five strongest FM stations will be auto-
matically stored on the “T” memory bank
(Travelstore). When this process has been
completed, the radio will play the strongest
station.
If desired, stations can also be stored ma-
nually in the Travelstore bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station at the touch
of a key.
•
Select the waveband by pressing
BND. For FM, also choose the corre-
sponding memory bank by pressing
BND as many times as necessary until
the desired memory bank appears in
the display.
• Press the corresponding station selec-
tion key briefly to recall the station.
Scanning stored stations with
Preset Scan
You can scan all of the stored stations on
any of the wavebands and in the selected
FM memory bank.
Preset Scan will not start unless PTY is
switched off (“PTY” will not light up in the
display).
•
If necessary press PTY.
To start Preset Scan:
•
Press SC for approx. 2 seconds.
All of the stations stored on the waveband
selected will be scanned one after the other.
“PS-SCAN” will flash in the display, alterna-
ting with the station name or frequency.
Radio operation with RDS (Radio Data System)