Venmar HEPA 3100* - Manual (Page 17)

5.6 I NSTALLING D UAL E XTERIOR H OOD ( CONT ’ D )
5.6.3 C ONNECTING T ANDEM ® TRANSITION TO EXTERIOR D UAL H OOD ( CONT ’ D )
2. Join the end of the Tandem transition to the rear of the exterior backplate. Secure with
2 Xmas tree pins and seal properly with duct tape.
3. Lean the exterior backplate to the exterior wall. Using 4 #8 x 1 ½” screws, fix it to the wall.
Seal the outline with caulking.
4. Snap the assembled exterior hood on its backplate and secure with 2 provided screws
(#8 x 3/4” long).
5.7 C ONNECTING THE D RAIN (HRV 2600, HR 2.6, HEPA 3100 AND HF 3.1 UNITS ONLY )
VD0085
CAUTION
The exterior backplate must be installed with the word “TOP’’ pointing upward.
Xmas tree pin
VD0086
VD0087 screw
5. INSTALL THE UNIT (CONT’D)
VO0025
1
VO0046
1
2
3
2. Hand tighten the 2 plastic
drain fittings (1) using the
gaskets (2) and nuts (3) as
shown. Close the door.
VO0027
27''
(686 mm)
7''
(178 mm)
3. Cut 2 sections of plastic tubing;
one 7’’ (178 mm) long and one
27’’ (686 mm) long, and attach
them to each drain fitting as
shown.