Vivitar 690HD User Manual
Page 50
49
Do not shake the camera to throw the water off.
Do not open the USB cover until the camera is totally dry.
Turn the camera around in all directions and notice if there are still signs of water before opening
the USB cover.
Warning:
If any water enters the USB cover, this will damage the camcorder.
If there is a little water on the edge of the USB cover when the door is opened, dry it carefully with a
soft cloth before opening.
Do not let the water get inside the USB port, SD card slot or AV out port.
Do not attempt to open the camcorder casing, tamper or dismantle the camcorder.
If the camcorder cannot be used correctly, please use a thin stick or rod and insert it into the reset hole
to reset the camcorder. The stick cannot be too sharp in order not to destroy the silicon inside the reset
hole.
If you use the camcorder in sea (salt) water, please rinse the camcorder with fresh clean water as
soon as you can afterwards. Sea water has a high salt content, as well as small particles of sand, and
this may damage the camcorder.