Vivitar ViviCam 3705 - Manual (Page 48)

48
Beep
The camera produces a sound (beep) each time you press a camera button, if this function is enabled. Press the button, then
select [On] or [Off] by using the / buttons and then press the button.
Power Off
If there is no camera activity (no buttons are pressed) for a defined period of time while the camera is powered on, the camera
will switch to an idle mode, and eventually turn itself off to conserve power.
Period of Inactivity (batteries) Period of Inactivity (AC power adapter) Camera status
60 seconds 60 seconds Idle mode
30 minutes 30 minutes Turn off
If the camera is idle, re-activate the camera by pressing any button on the camera. If the camera has powered-off you must to
turn the camera on again by pressing the button.
The table (above) shows the default time settings for idle, and power-off.
You can change the power saving interval by pressing the button. Then, use the / buttons to select the desired interval
time (from 1 to 30 minutes), and press the button.