beautypg.com

Connecting a pc – VIEWSONIC VPW505 User Manual

Page 11

background image

ViewSonic VPW505

9

Connecting a PC

Using RGB or DVI Video Input
1. For most PC’s, connect the 15-pin D-Sub RGB connector from

the back of the PC to the RGB-IN Connector located on the back

of the display. If you have a PC that is equipped with a DVI

(Digital Visual Interface), you may connect the PC DVI connec-

tor from the back of the PC to the DVI-In Connector located on

the back of the display.

2. Connect the red (R) and white (L) audio jacks from the PC to the

R and L jacks located to the left of the S-VIDEO connector. If

you are using a DVI interface, simply connect the (R) and (L)

audio jacks to the R and L jacks located to the left of the VIDEO

1 connector.

Notes:
„ Your PC may have audio jacks in the form of a 3.5mm phono

plug. If this is the case, you will need to use a phono-plug to

RCA converter cable in order to connect audio.

„ A RGB loop-out labeled “RGB Out” will allow another RGB

display to be connected. The RGB loop-out will display the

same signal as the RGB In signal source.

„ The physical display resolution is a maximum of 1024x768 dots

when aspect ratio is set to “4:3”, and 1366x768 dots when set to

“16:9”. If the PC’s display resolution exceeds these maximums,

the display will have to artificially eliminate dots in order to fit

within the physical dot capability of the display; therefore, it is

possible that the display may not be able to show details with

adequate clarity.