Vista 0150-0267A - Manual (Page 18)

Vista Solo 2-4 0150-0267A
Search Filters
Start
DATE: 12/25/00 [ ]
(MM/DD/YY)
Stop
01/01/01 [ ]
(MM/DD/YY)
Start
TIME: 11:11:21 [ ]
Stop
12:34:34 [ ]
1 2 3 4 5 6 7 8
CAMERA: [ ][ ][ ][ ][ ][ ][ ][ ]
ALARM: [ ]
Use this to specify:
•
The Start and Stop date of
the search.
•
The Start and Stop time of
the search.
•
Which cameras to search
exclusively.
•
To search for recorded
alarms.
[CANCEL] [START SEARCH]
Searching for All Recorded Events
Using the Arrow buttons to navigate, highlight [START SEARCH], then press the Enter button. The
Search Results window will appear. For information about selecting a recorded event, see Selecting
from the Search Results, in this section.
2.4 Specifying Search Parameters
Selecting a Start and Stop Date
1. Using the Arrow buttons to navigate, highlight the DATE parameter, then press the Enter button.
The unit will enter Edit mode.
2. Use the Arrow buttons to change the start and stop date values. Use the Arrow buttons to
navigate among the different parameters.
3. To activate the start or stop date parameter, use the Arrow buttons to place an [X] in the check
box.
4. Press the Enter button at any time to exit Edit mode.
Selecting a Start and Stop Time
1. Using the Arrow buttons to navigate, highlight the TIME parameter, then press the Enter button.
The unit will enter Edit mode.
2. Use the Arrow buttons to change the start and stop time values. Use the Arrow buttons to
navigate among the different parameters.
3. To activate the start or stop time parameter, use the Arrow buttons to place an [X] in the check
box.
4. Press the Enter button at any time to exit Edit mode.