Programming remote control – VIEWSONIC CD4200 User Manual

Page 40

ViewSonic CD4200

ENGLISH

PROGRAMMING REMOTE CONTROL

Direct Device Code Setup

Although your Remote Control is set up to provide control of
this LCD, you can specify other devices to be controlled,
according to the following steps:

Each code in the following pages insists 5 digits from 0 to 9.

Mode → <> (2 blinks) → 5- digit device codes (2 blinks)
STEP 1 Locate the desired device in the Device code list.

STEP 2 Select the mode by pressing VCR, CBL, or AUX.

STEP 3 Depress and hold <> button for a minimum of 3 seconds until LED blinks

twice.

STEP 4 Enter the 5-digit code for the desired device. The LED blinks located on the

remote control once for every digit entered except for the last digit, where it shall
blink twice to confirm that a valid code has been programmed.

Mode

Device Assignment

Device

Group no.

Locked to this LCD (Default)

-------

VCR

Universal VCR, DVD, PVR

CBL

Universal Cable, Satellite, Video Accessory

AUX

Universal Tuner, Amplifier, CD, Mini Disc. And Misc. Audio,
Home Automation

Example: [VCR]→<> (2blinks)→[2]→[0]→[0]→[3]→ [5] (2 blinks).

NOTE 1 : Each digit must be entered within 10 seconds, or the Remote Control shall exit the current

programming state.

NOTE 2 : Two short LED blinks indicate valid code.
NOTE 3 : A long LED display indicates invalid code sequence. The code should be re-entered.