VistaQuest VQ3015 - Manual (Page 16)

- 11 -
7. Taking Pictures
• Taking a Picture
1. Turn on the camera.
2. The LCD monitor will display image and symbols.
3. Slide the
Function switch to (capture status).
4. The LCD monitor will display (Snapshot Mode).
If icon is different, Press the Menu button and then press to
select [Burst Snapshot ], and then press or to select [single] and then press the
Menu button to exit the menu.
5. Point the camera at the subject; use the monitor screen or the viewfinder to compose the
image. (If turn the Macro switch to , you can take picture as close as 50cm.)
6. Holding the camera still, gently press the Shutter button to take the picture.
Note: How to take a good shot? After pressing down shutter button, keep your hand steady for
2 seconds to get best result.
• Taking Continuous Pictures
1.Make sure the Function switch is set to . (Capture Function)
2. Press the Menu button and then press to select [Burst Snapshot], and then press or
to select [Burst] and then press the Menu button to exit the menu. And the icon
will appear on the LCD monitor.
3. Point the camera at the subject; use the monitor screen or the viewfinder to compose the
image.
4. Holding the camera still, gently press the shutter button to take the picture.