VistaQuest VQ3015 - Manual (Page 15)

- 10 -
• Setting the Date, Time and Date Stamp:
Use the following procedure to change the date and time setting.
1.Slide the
Function switch to (capture status).
2.Press the Mode button twice to turn on function menu. Press the
Shutter button.
3.Press or to adjust the date and time. Press or
to advance to the next setting.
5.When finished, press the Shutte r button to confirm the setting; press the Menu button to
return to main menu, press the Mode button to exit the menu.
Use the Date Stamp setting to imprint the date on your pictures.
In the Date Time Setting menu. Make sure the VQ3015 clock is set to the correct date.
1. Slide the
Function switch to (capture status).
2. Press the Menu button and then press or to select [Time Stamp] option.
3. Press or to select [Date Only] or [ Date&Time]
4. Press the Menu button to exit the menu.
• Power Saving:
The VQ3015 will automatically power off approximately 30 SEC,1MIN, 3MIN, 5MIN (selectable)
after you do not perform any operation.