VIEWSONIC CD4225 - Manual (Page 16)

ViewSonic CD4225 14
How to Mount and Attach Options to the
LCD Monitor
Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged,
beneath the screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure
to follow correct mounting procedures could result in damage to the equipment or injury to the user or
installer. Product warranty does not cover damage caused by improper installation.
Failure to follow these recommendations could result in voiding your warranty.
Use M6 mounting screws (having a length 10-15mm longer than the thickness of the mounting bracket)
and tighten them securely. (Recommended torque: 470 - 635N•cm). The mounting interface should
comply with the UL1678 standard in North America. The mounting means should strong enough to bear
the weight of the monitor (approx. 24.5kg without stand). ViewSonic recommends using mounting
interface that comply with TÜV-GS standard.
Caution:
For preventing the monitor from falling.
• Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your
own responsibility. For detailed procedures of installation, refer to the instructions of the metal
brackets.
• To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake
or other disaster, be sure to consult the bracket manufacturer for installation location.
• To lessen the risk of falling of the monitor, thread commercially available rope (having a load capacity
at least 1960N (200kgf)) through the handles at the right and left of the monitor and secure the rope to
the wall mount brackets or ceiling mount brackets.
• Do not sleep where the monitor may topple over or fall in case of an earthquake or other disaster.
400mm
200mm
200mm
LCD monitor
10-15mm
Thickness of the
mounting bracket