VIEWSONIC VS11770-2M - Manual (Page 40)

ViewSonic N3235w / N3735w 35
ENGLISH
Contact ViewSonic service team at: http://www.ViewSonic.com or call our service team: United States 1-800-688-6688, Canada 1-866-463-4775
Using the TV Features
Using VGA Function
1. When in VGA source, press the MENU button to
display the OSD main menu.
2. Press ◄ or ► to select the “Video” menu.
3. Press ▲ or ▼ to select your desired controls, and press
◄ or ► to adjust.
4. For advanced VGA functions, select “VGA” (only
enabled in VGA source) and press ENTER to enter
VGA setting.
5. Press ▲ or ▼ to select “H. Position”, “V. Position”,
“Phase”, or “Clock”, and adjust the level with ◄ or ►.
＊
When in VGA source, the Audio, Setup, and Parental
menus are the same as or similar to when in other source.
Instead that some controls are disabled.
＊
When there is no signal in the VGA mode, “No signal.
The power will be turned off.” will be displayed on the
screen, and the TV will automatically turn into power-
saving mode after a few seconds’ idleness. Press any key
on the remote control at any time and the TV will return
to VGA mode.
To Restore Factory Setting
1. Press the MENU button to display the OSD main menu.
2. Press ▲ or ▼ to select the “Setup” menu.
3. Press ENTER or ► to enter “Setup” menu.
4. Press ▲ or ▼ to select “Memory Recall”, then press
ENTER to restore the factory default setting.
Change Password:
1. Press ▲ or ▼ to select “Change Password”, then press
ENTER to enter “Change Password” setting.
2. Enter your new password in “New Password”.
3. Enter the new password again in “Confirm Password”.
After you complete the last step, the screen will return
to the top page of Parent menu. If so, the password has
been changed successfully.