Vector 6SE70 VC User Manual
Vector Hardware
Table of contents
Document Outline
- Vector Control
- Section 1: Parameterization of Base Drive
- Section 2: Parameterization of Rectifier
- Section 3: Simovis Trace Setup Method
- Section 4: When Should a Drive be re-Tuned
- We reserve the right to modify functions, technical data, standards, drawings and parameters.
- We have checked the contents of this document to ensure that they coincide with the described hardware and software. However, deviations cannot be completely ruled-out, so we cannot guarantee complete conformance. However, the information in this docum
- e-mail: mailto:[email protected]
- Note:
- Electrical equipment has parts an components which are at hazardous voltage levels.
- Section 1:
- Vector Control
- Power Section Definition
- 1.2 Factory Reset
- 1.3 Basic Start-up without Motor Connected to Load
- Connect External Wiring as connection diagram.
- Step 1: Dry set of contacts between terminals X101, pin#1 and pin#5 for Local/Remote Mode Selection. Jumper if not required.
- Step 3: Dry set of contacts between terminals X101, pin#1 and pin#9 for Source of Main Start/Stop Selection.
- Step 5: Dry set of contacts between terminals X101, pin#1 and pin#6 for Fixed Speed or Preset Speed Selection. Leave open if not required. Speed value is determined by P402. A selection of P402=100% will be a full speed reference setpoint.
- 1.3.2 Volts/Hz with Encoder
- Additional Connection for +15 Vdc Encoder.
- Step 10: Set Speed Reference to 20%.
- Step 11: Provide Start command. Note that if Signal A and Signal B are reversed, the motor will accelerate rapidly.
- Step 12: Connect the motor to the load, unless the plan is to change to Vector Control.
- 1.3.3 Vector Control without Encoder Feedback
- Step 10: Set Speed Reference to 20%, and monitor speed feedback r000, current feedback r004, and actual DC BUS r006. If stable increase speed in increments and continue to monitor feedbacks.
- Step 11: Set Speed Reference to 20%, and monitor speed feedback r000, current feedback r004, and actual DC BUS r006. If stable increase speed in increments and continue to monitor feedbacks.
- Vector Control
- Power Section Defintion
- Factory Reset
- Basic Start-up
- Rectifier or Regen without auto-transformer
- Regen with auto-transformer
- 2.0 Power Section Definition
- 2.1 Factory Reset
- 2.2 Basic Start-up (Regenerative Rectifier without Autotransformer)
- 2.3 Basic Start-up (Regenerative Rectifier with Autotransformer)
- Vector Control
- Vector Control
- 4.0 Conditions that would merit re-tuning the drive