Power section definition – Vector 6SE70 VC User Manual
Page 7
Version 1.0 March 1, 2000
Page 7
1.1 Power Section Definition
Note: Power Section is pre-defined at the factory. Power Section
Definition is required if a new board CUVC board is put into the drive or
boards are switched between units with different ratings. Drive should
be defaulted and re-parameterized after Power Section Definition.
P060 = 8
P070 = ?
P060 = 1
Select “Power Section Definition”
Menu
Input Code for unit (PWE)
(Refer to Compendium section
6.3 or use the bookmark “PWE
Listing” or check the following
table)
Return to Parameter Menu