Pioneer DJM-350-W - Manual (Page 6)

DRB1501-D
En 6
6
Connections
Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections.
Refer to the operating instructions for the component to be connected.
Connect the power cord after all the connections between devices have been completed.
Be sure to use the included power cord.
Names of terminals
Rear panel
AC IN
MASTER OUT CH-2
1
L
R
2 PHONO
CONTROL
SIGNAL
GND
L
R
CD
CH-1 AUX
MIC
PHONO
CONTROL
L
R
L
R
CD
1 2 7 8 9 3 4 5 3 4 5 6
1 AC IN
Connect to an AC outlet. Plug in the power cord after all connections
have been made.
Be sure to use the included power cord.
2 MASTER OUT 1, 2 (page 7)
Connect to a power amplifier, etc.
3 PHONO (page 7)
Connect to an analog player or other phono level (MM cartridge)
output device. Do not connect to a DJ player or other line level device.
4 CD (page 7)
Connect to a DJ player or other line level device.
5 CONTROL (page 7)
Connect using a control cord (included with Pioneer DJ players).
6 SIGNAL GND (page 7)
Connect an analog player’s ground wire here. This helps reduce
noise when the analog player is connected.
7 AUX (page 7)
Connect to the output terminal of an external device (sampler, por-
table audio device, etc.)
8 MIC (page 7)
Connect to a microphone.
9 Kensington security slot
Front panel
a
a PHONES (page 7)
Connect headphones here.