VXI BlueParrott B100 - Manual (Page 16)

End the Call
Quickly press the multifunction button on the headset for 1 second. Afterwards, you
will hear a single beep. The call will be disconnected and the headset will revert to
Standby Mode.
Adjust Receive Volume
To adjust the volume in your earpiece, press the increase or decrease volume button
for 1 second, then release. Repeat until volume is at desired level. You will hear a
single beep each time you press the button.
Mute The Microphone On The Headset
To mute the microphone, press and hold down the Increase Volume button for 4
seconds. You will hear a beep and the microphone will mute. A beep will be heard
periodically indicating that the microphone is in Mute Mode. This will not be heard on
the other end of the call.
Un-Mute The Microphone On The Headset
To un-mute the microphone, press and hold down the Increase Volume button for 4
seconds. You will hear a beep and the microphone will un-mute.
Switch From Handset To Headset While On A Call
1. Before hanging up the handset, make sure the headset is in Standby Mode and then
activate the headset by pressing the multifunction button for 1 second. Afterwards,
you will hear a single beep and both handset and headset will be on the call.
2. Next, hang up the handset as you normally would. The call will remain active on
the headset until the parties end the call.
Switch From Headset To Handset While On A Call
1. Before disconnecting the headset from the call, remove the handset from the
phone’s cradle (corded phones) or turn the handset on (cordless phones). Both the
headset and the handset will be on the call.
15
Blue Parrott B100 Wireless Headset Blue Parrott B100 Wireless Headset
12
HEADSET ADJUSTMENTS / MICROPHONE POSITIONING
The Blue Parrott B100 includes a professional grade headset that offers stability and
excellent audio quality. Microphone positioning is important to ensure proper
performance of the microphone.
Headset Adjustment
1. Place the headset on your head with the ear cushion on your left or right ear.
2. Swivel the microphone boom up and over, if necessary, to bring it to the chosen
side.
3. Position the T-bar on the side of your head above your ear.
4. Slide headband in or out for a secure fit.
Microphone Positioning
1. The microphone has the word TALK or a small dot imprinted on it under the
cushion. This mark must face your mouth.
2. For good quality voice input and effective background noise cancellation, be sure
to position the microphone a finger’s width away from your face, just below your
bottom lip.