VXI BlueParrott B100 - Manual (Page 10)

INSTALLATION
The Blue Parrott B100 connects directly into the phone line wall jack. You may add a
telephone directly to the B100 system, or you can install the B100 independently to
its own telephone wall jack.
However, if you install the Blue Parrott B100 base to a telephone wall jack separate
from your phone’s location, be sure it is installed within the acceptable range from
your phone so that you will be able to dial out while wearing your headset (see
Range on page 8).
Refer to label on base for connections.
STEP 1: Connect the Blue Parrott B100 to the telephone wall jack.
Take the “Line” cord that came with this unit and plug it into the
“LINE” port on the bottom of the Blue Parrott B100 base. Plug
the other end into your telephone wall jack (if your phone is
plugged in here, disconnect your phone from the wall).
STEP 2 (Optional): Connect the Blue Parrott B100 to your telephone
Take the cord that you removed from the wall jack (it should
still be attached to your phone) and plug it into the “PHONE”
port on the bottom of the Blue Parrott B100 base.
9
Blue Parrott B100 Wireless Headset
TO WALL JACK
TO WALL JACK TO TELEPHONE
Blue Parrott B100 Wireless Headset
18
Before Pairing : Take the B100 Headset and Base Out of Standby Mode
Before pairing remove the B100 headset from the base and take them both out of
Standby Mode:
To take the B100 headset out of Standby Mode: Press and hold down the
multifunction button for about 4 seconds. You will hear 3 beeps in the headset that
descend in tone and the yellow light on the headset will stop flashing.
To take the B100 base out of Standby Mode: Press and hold down the pairing button
for about 4 seconds. The yellow light on the base will stop flashing.
Pair the Blue Parrott B100 Base With The Blue Parrott B100 Headset
Be sure the headset is out of the base and both are out of Standby Mode.
1. Turn off the alternate Bluetooth product or keep it at least 50 feet away.
2. Position the B100 base and B100 headset no more than 3 feet apart.
3. Press and hold down the pairing button on the B100 base for approximately 5 to
15 seconds until the red and orange indicator lights on the base begin to flash
alternately. Release the pairing button.
4. Press and hold down the left side of the multifunction button on the B100 headset
until you hear a series of melodic tones and the yellow and red indicator lights
begin to flash alternately. Release the multifunction button.
5. In 5 to 15 seconds, the indicator lights on the B100 base and headset will cease
flashing.
6. Successful pairing has been completed.
Pair the Blue Parrott B100 Base With A Different Bluetooth Headset
See compatibility section of this user guide for headset compatibility information.
Be sure the B100 headset is out of the base and both are out of Standby Mode.
1. Position the B100 base and your alternate headset no more than 3 feet apart.