Vantec EZ-SWAP 2 MRK-300FD-BK - Manual (Page 10)

3-10 Aluminum Mobile Rack
To insert the Mobile Rack drive case:
1. Insert the Mobile Rack drive case (with drive installed) into the installed Mobile
Rack docking case and push firmly until the drive is seated.
2. Insert the key and turn it right to lock. The LED on the Mobile Rack should
light after a slight delay. The installed Mobile Rack device is ready to use.
To remove the Mobile Rack drive case:
1. Insert the key and turn it left to unlock. Note that the power LED on the
Mobile Rack should now be OFF.
2. Gently pull on the Mobile Rack handle to slide the drive case out.
WARNING
• DO NOT remove the drive case while the drive is working.
Damage to data may result.
• The Key-Lock must be in the Lock position while in use.
Key-Lock in
Lock Position
Key-Lock in
Unlock Position
3-3 Using the Mobile Rack