VocoPro DA-8808VE - Manual (Page 15)

14
1. POWER - This remote control button turns the DA-
8808VE ON/OFF
2. INPUT SELECTOR - These buttons switch between the sig-
nals from CD, CDG, LD and DVD inputs. Whicever player or
source music is connected to these respective AUDIO INPUTS
will be activated with these keys.
3. MIC VOLUME - Use the to raise the MIC MASTER
VOLUME (front panel, #5) and the to lower this mixed MIC
MASTER VOLUME. You will see the controls on the DA-
8808VE move as you make adjustments using the remote
keys.
4. MUSIC VOLUME - Use the to raise the MUSIC VOLUME
(front panel, #6) and the to lower the MUSIC VOLUME. You
will see the controls on the DA-8808VE move as you make
adjustments using the remote keys.
The maximum operating distance between the Remote Control and the REMOTE SENSOR is approximately
23 feet. If the effective distance of the Remote decreases, replace the batteries. To install new batteries,
remove the battery compartment lid on the back of the Remote and insert two AAA batteries with polarities
aligned.
Remote control descriptions and functions
DVD
CDG
VOC/C
DIGITAL KEY CONT.
CD
VOC/P
LD
MIC VOL
POWER
SELECTOR
INPUT
Multiplex
DA-8808VE
b #
MUSIC VOL
THE SINGER'S ULTIMATE CHOICE TM
R
6
5
2
3
4
1
23 feet
23 feet
5. VOCAL CANCEL/VOCAL PARTNER - With Multiplex media, lead vocals and music are
recorded in separate left and right stereo channels. When the VOCAL CANCEL (VOC/C) button on the
remote is selected, the LED will illuminate and the lead vocal channel will be removed, leaving a duplicated
instrumental track to left and right only. When VOCAL PARTNER (VOC/P) is pressed, the LED will illuminate
and the vocal track will only be activated only while there is no microphone input. In other words, while the
Karaoke singer is performing, the vocals will never drop entirely out, keeping the action going.
6. DIGITAL KEY CONTROL - You can adjust the key of your source music in half-step increments to match
the natural range of your voice using the KEY CONTROL buttons on the remote control. To flat (b) or lower
the key, press the left KEY CONTROL button. To sharp (#) or raise the key, press the right button. To
return to the original key of the music input source, press the center button. You will see the DIGITAL KEY
DISPLAY reflect the number of steps you have increased or decreased displayed as numerals with +/-, or 0
for the original key.