beautypg.com

Care and maintenance – Vinotemp VT-6TED-WW User Manual

Page 11

background image

11

1 7 6 3 1 S . S u s a n a R o a d , R a n c h o D o m i n g u e z , C A 9 0 2 2 1

[email protected]

CARE AND MAINTENANCE

Unplug the power source before cleaning your wine cooler.

Do not store chemicals in or near your wine cooler. Be especially
mindful that the rear of your wine
cooler is the hottest part.

Clean the dust on the anti-dust
net of ventilation inlet regularly to
ensure proper ventilation. Detach
the inserting board to clean the
dust in ventilation pipe.

Drain the condensed water inside
the box once every week.

Arrange the wine bottles with the
bottoms of wine bottles 5cm away
from the ventilation outlet.

Remember that your wine cooler
can only cool wine bottles if the
room’s ambient temperature is
not too low. If the ambient
temperature drops below the
setting you have selected to chill your wine to, the wine cooler will
chill to match the ambient temperature. This can run the risk of
freezing, so make sure you have taken a room’s temperature
range into account before you set your wine cooler up in one.

Do not use hard brushes, soap or detergent to clean the inside
cabinet. Simply wipe it with a dry, clean piece of cloth.

Do not place any electrical appliance on top of your wine cooler.

Do not try to force out the chrome shelves from your wine cooler.
To remove the shelves, always pull them out gently, and be
careful of obstructions particularly the gasket seals.

Never close the door forcefully apart because the performance of
the hinge may suffer.

Never use oil to lubricate the hinge as oil may seep down and
subject the rubber seal to cracking.

If a power failure occurs, avoid opening the wine cooler door.
Most power failures are corrected within a few hours and
shouldn’t affect the temperature in your wine cooler as long as
you don’t open the door too often. If the power is going to be off
for a longer time, you should be careful that you don’t expose
your bottles to a dramatic warming as condensation or the
chance of mold developing may occur.