VistaQuest VQ-7024 - Manual (Page 12)

- 8 -
6. Getting Started
• Installing Camera Batteries:
1.Slide open the battery compartment cover.
2.Insert batteries. Be sure to load batteries with + and –
terminals as shown on the camera.
3.Slide close the battery compartment cover.
• Inserting SD Card:
The camera offers two options for storing pictures and videos:
Internal Memory: Store pictures and videos in the 32 MB internal memory.
SD Card – The SD cards provide removable, reusable storage for pictures and videos. Store
as many pictures as you like, depending on the size of the card.
CAUTION:
The card can only be inserted one way; forcing it may damage the camera or card.
Do not insert or remove a card when power is on.
Please note that not all SD cards may work in this camera. If one brand fails to
operate even after reformatting then another brand of SD card must be used.
To insert an SD card:
1. Turn off the camera and open the battery compartment cover.
2. Orient the card as shown. Push the card into the slot to the connector.
3. Firmly to remove the card, push it in, and then release it.
When the card is partially ejected, pull it out.
4. Close the battery compartment cover.
Note: 1.If the SD card is present in the camera, and then the picture/ video
will save in the SD card. If no card is installed, the camera uses internal memory.
2.If the “MEMORY FULL” warning message appears on the TFT panel, it means the
SD card or internal memory is full. Please remove the memory and insert a new one
or move/store all picture/video in memory to your computer.