VOX Amplification USA AGA70 - Manual (Page 7)

7
3. [GUITAR] connector
Plug in your guitar (or other acoustic musical instrument featuring a pick-up) using a high-quality
shielded cable.
NOTE: If you plug in your instrument to this connector, the [MIC] connector on the same channel will
be disabled.
4. [GAIN] switch
Set the input gain to “LOW” or “HIGH” depending on the volume level of the musical instrument
connected to the [GUITAR] or [MIC] connector.
5. [MIC] connector
Connect your microphone to this balanced XLR connector.
6. [PHANTOM] switch
Turn this switch on when you connect a condenser microphone that requires phantom power. When
the phantom power is being supplied, the indicator above the switch lights up.
NOTE: If the microphone does not require phantom power, turn the [PHANTOM] switch off.
NOTE: Before you turn the [PHANTOM] switch on or off, be sure to set the [MASTER] volume control
to minimum. Also, before you connect a microphone to the [MIC] connector, be sure to turn the
[PHANTOM] switch off.
7. [VOLUME] control
This control knob enables you to adjust the volume level of the musical instrument connected to the
[GUITAR] or [MIC] connector. Use this control on each channel to adjust the level and balance be-
tween the Normal and Tube Pre channels.