Uniden XS1215 +1 - Manual (Page 25)

4) Enter a name according to the instructions below, then press the key (XS1215) or the
key (XS1215+1). If no name is required, go to step 5.
• The name can be up to 13 characters.
• Use the and to move the cursor to the desired location.
• Use the key (XS1215) or the key (XS1215+1) to delete
characters as needed.
• Press and hold the key (XS1215) or the key (XS1215+1) to
delete all the characters.
Refer to the letters on the number keys to select the desired characters.
With each press of a numeric key, the displayed character appears in the following order: upper case
letters first, lower case letters next and finally the number corresponding to the key.
If you make a mistake while entering a name Use the key to move the cursor to
the incorrect character. Press the key (XS1215) or the key (XS1215+1)
to erase the wrong character. Then enter the correct character. To delete all characters, press and hold
the key (XS1215) or the key (XS1215+1).
For example, to enter
1) Press . Then press the
key to move the cursor to the right.
2) Press six times.
3) Press six times.
4) Press six times.
5) Press five times.
6) Press eight times.
select
select/channel
#/ /tone/
delete/channel delete/transfer
delete/channel delete/transfer
/tone/ #/
delete/channel delete/transfer
delete/channel delete/transfer
#/
6
8
4
3
7
keys
or
Movies.
6
If the next character
uses the same
number key, you
must press the
key to move the
cursor over.
Otherwise the next
time you press the
number key, it
changes the
character that was
previously set.
#/
[24]
USING
THE
SPEED
DIAL
MEMOR
Y