Uniden PS-0035 - Manual (Page 3)

Installing Your Phone
Charge the Battery
Unpack all handsets, battery packs, and battery
covers. If any battery cover is already on
the handset, press in on the notch and slide
the cover down and off.
Line up the red and black wires on the
battery pack with the label inside the
handset.
Push the battery pack connector in
until it clicks into place. Tug gently
on the wires to make sure the battery
pack is securely connected.
Place the cover over
the battery
compartment and
slide it up into place.
Connect the base
AC adapter
to the
AC IN 7.8V
jack on the
back of the
base. Route
the cord
through the
molded wiring
channel as
shown.
If you have accessory handsets, connect
a charger AC adapter to each charger's
AC IN 8V
jack and set the plug into the
notch as shown. (These adapters might
already be connected.)
Plug the other end of each adapter into
a standard 20V AC power outlet.
)
2)
)
)
)
)
)
Red
Black
Red
Black