Uniden PS-0035 - Manual (Page 18)

Adjusting the Base Visual ringer
The VISUaL rINGer switch is at the back
of the base; use this switch to change the
brightness of the base visual ringer. (It
doesn't affect the audio ringers.)
Slide the switch so that its center (marked
with the arrow in the picture) lines up with
the brightness you want to use:
HIGH
,
LoW
, or
oFF
.
Using the Audio Boost
You can increase the earpiece volume for normal calls and intercom calls.
During a call, press bOOST to increase the volume of the audio. While
audio boost is on, appears in the display. Press bOOST again to turn off.
Using Text-To-Speech
With the Text To Speech (TTS) feature, your phone can announce phone
numbers or names in several different situations.
When you... (from standby) The phone announces...
Receive a call
The caller's name (if sent by a Caller ID service)
Dial a number The phone number you dialed
Open the phonebook The name of the entry you are looking at
Things to know about TTS:
You have to turn on TTS separately for each handset. Open the menu
and select Handset Setup. Then, select TTS On/off, and select On or
Off for each handset.
To make sure it doesn't interrupt a call or an intercom page, the phone
only uses TTS when it starts out in standby. For example, if you open
the phonebook during a call, the phone won't announce the names in
your phonebook.
It takes at least 2 rings for the phone to receive Caller ID information
and announce it. If the phone is answered before the end of the second
ring, the phone won't have time to announce the name of the caller.
To change the volume used for CID announcements, change the ringer
volume. For other TTS features, change the handset speaker volume.
The TTS feature only uses English to announce the name and numbers,
regardless of what language is use for the display.




