Universal Remote Control (URS) Universl Remote - Manual (Page 14)

SECTION 2: Auto-Search Method
The Auto-Search Method is a way you can scan through all the
codes in the table to find the right code for your component.
STEP 1: Using your old remote, turn on the component you want
to program with the GAMER... let’s say your TV.
STEP 2: Now, press down on the component button, in this case the
button that says TV, and the SELECT (SEL) button at the same time.
Hold them both down for 3 seconds until the TV component button
LED light turns on.
12
IMPORTANT: If you don’t press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and you will need
to start over.
STEP 3: Press and release the UP ARROW button. Please note,
each time the Up Arrow is pressed, the code will count up one code
number and send a Power OFF signal. When the correct code is sent
out, the component will turn off.