Uniden DS72 - Manual (Page 25)

23
3. Press speaker on the base unit to establish communications between the calling party.
▼ Transferring a call from the Base Unit to the Handset
1. During a call, press int on the base unit, the call is placed on hold automatically
and the handset is paged. (If there is no answer press int again to return to the call
on hold).
2. At the handset, press int to answer the page. An intercom link is now established
between base unit the and the handset. Speak into the microphone.
3. Press talk on the handset to establish communications.
▼ Entering Handset Memory Numbers
1. Remove the handset from the base.
2. Press mem . The talk LED blinks.
3. Enter the phone number, up to 16 digits.
If a pause is needed during dialing
to access long distance service, press
redial/p to insert a pause.
4. Press mem again.
5. Enter the memory location (01-20) on
the keypad. A tone indicates that
the number is stored.
▼ Entering Base Unit Memory Numbers
1. Press mem . The in use/hold/mute LED blinks.
2. Enter the phone number, up to 16 digits.
If a pause is needed during dialing
to access long distance service, press
redial/p to insert a pause.
3. Press mem again.
4. Enter the memory location (01-20) on
the keypad. A tone indicates that
the number is stored.
charge
speaker
in use/hold/mute
power
flash redial/p
int mem hold mute
vol
inuse/hold/mute
redial/p
mem
talk
mem redial/p
STORING A PHONE NUMBER IN MEMORY
The pause button count
as one digit. Pressing
redial/p more than
once increases the length
of pause between numbers.
USING YOUR PHONE