Uniden BC250D - Manual (Page 83)

79
assigned theoretically, and the values
are not to guarantee the operation of
the unit.
• The Mid threshold value will not change while
adjusting the upper and lower limits.
4. Once you have adjusted the Sound Quality to the
lowest possible level, press the E key.
Press the RSM key to exit the Sound Quality
Adjustment Mode.
* To cancel the adjusted threshold level, press
(Decimal) key.
* The adjusted threshold level for the current frequency
can be set back to the default value by pressing and
holding the
(Decimal) key.
* When you change the Sound Quality it affects all
other APCO P-25 signals in that same band. (UHF,
VHF, or 800MHz)
* You cannot enter the “Sound Quality Fine Tuning”
mode when the scanner is operating as follows:
1) The receiving frequency is 0 MHz.
2) Air Band Frequency
3) BCi25D card is not inserted
4) BCi25D / P-25 monitoring is disabled
.
.
BC250D 11/6/2 11:37 AM Page 79