Uniden BC250D - Manual (Page 17)

13
Setup
Installing the Battery Pack
1. Open the cover.
2. Connect the battery pack connector
observing the correct polarity.
3. Replace the cover and press down
until it clicks into place.
Charging the Battery Pack
Use the AC Adapter/Charger
to power the BC250D from an
AC outlet.
You can use your scanner
while the battery charges.
To fully charge the battery,
leave the AC Adapter/Charger
connected for 14 — 16 hours.
Note: Disconnect the AC Adapter/Charger from the unit when
charging is complete.
Low Battery Indicator
When the battery pack is low and needs to be charged,
appears on the display. You will also hear a beep every 15
seconds as an audible alert.
HOLD/ MAN
CH/
FRQ
RSM
SCAN SERVICE SEARCH
MENU/BACK
L/O
SELECT MUTE REVERSE
TRUNK
Use only the supplied AC Adapter
BC250D 11/6/2 11:36 AM Page 13