Error, Selecting trunking programming menu mode, Selecting trunking system type – Uniden UBC780XLT User Manual
Page 44
34
☞
Important!
7. Press
TRUNK
for 2 seconds.
A tone sounds, and
E
,
M
, or
L
icon appears on the
display according to the system selected.
Note: • To clear a mistake while entering the frequency,
press
(decimal key) repeatedly until the
display is cleared.
• If you enter a frequency which is out of the
system’s trunking range, a distinctive beep
sounds and
ERROR
appears on the display.
• Repeat Step 7 for every trunk frequency
entered.
Selecting Trunking Programming Menu Mode
To change the system type which your scanner monitors, you must be in the Trunking
Programming menu mode.
To select this mode, follow these steps:
1. Press
MENU
.
2. Press
▲
or
▼
to select TRUNK DATA and then
press
E
.
3. Select the bank you want to program using
▲
,
▼
or VFO and then press
E
.
☞
Remember! You can also use the VFO control for scrolling. Also instead of pressing
E
, you can press the VFO/SELECT control or press the
SELECT/MUTE
key.
Selecting Trunking System Type
1. Select TRUNK TYPE using
▲
,
▼
or VFO and then
press
E
,
SELECT
or VFO.
2. Select the system type you want to program
using
▲
,
▼
or VFO and then press
E
,
SELECT
or VFO.