Uniden DSS 7805WP - Manual (Page 8)

Replace the rechargeable handset battery pack
1. Remove the 4 screws holding the
battery compartment with a screwdriver
and take off the battery cover. Remove
the old battery pack in the battery
compartment.
2. Plug the replacement battery
connector (red & black wires) into the
small, black jack inside the battery
compartment. (The connector notches
fit into the grooves of the jack only
one-way.) Match the wire colors to
the polarity indicated in the battery
compartment, connect the battery and
listen for a click to insure connection.
3. Make certain you have made a good
connection by slightly pulling on the
battery wires. If the battery connector is
not securely connected, the handset will
not charge properly.
4. Before placing the battery cover back on
the handset, make sure there is no
foreign matter under the rubber seal
located on the under side. By
inserting the bottom first, place the
battery cover back on the handset and
tighten the 4 screws.
Recheck that the screws are
tightened. You may void the Warranty
if the battery cover is not screwed on
firmly and moisture allowed to
seep in.
If the rubber seal appears worn, nicked,
or dried out, replacement seals are
available. Please see our website at;
Australian model: www.uniden.com.au ,
New Zealand model: www.uniden.co.nz.
Rubber Seal
7