Uniden DSS 7805WP - Manual (Page 5)

Charging the Accessory Handset
The handset is powered by a rechargeable battery pack that automati-
cally recharges when the handset is placed in the charger. Unlike your
typical household phone chargers, your new waterproof accessory
handset uses an enclosed charging method called magnetic inductive
charging. This type charger allows us to charge your handset without
exposing any electronic components; therefore, making it safer to use
around water or in highly humid environments.
1. Connect the AC adapter to the
DC IN 21V jack and to a 240V
AC outlet that is not controlled
by a wall switch.
Caution: Use only the
Uniden AAD-7805WP adapter.
2. Set the charger on a desk or
tabletop, and place the handset
in the charger with the
keypad facing forward.
3. Make sure that the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in.
4. Charge the handset battery pack for at least 25 hours before using
your new handset for the first time.
Notes:
The charger is not water submersible. Wipe off dirt or shake
water from handset before placing in the base.
Due to the enclosed type of magnetic inductive charging used
with this model, it will be normal for the bottom of the handset
to be warmer than room temperature when you first remove
it from the charging cradle. However, the warmth should not be
excessive or uncomfortable to touch.
•
•
4