Uniden DS 805 - Manual (Page 22)

18
Y
OUR
NEW
PHONE
If your phone is not performing to your expectations, please try these simple steps
first before calling Uniden customer service -
QUICK REFERENCE CHART
No dial tone
Check that the phone line cord connectors at both ends
are pushed in until they click.
If you have had a power failure or have unplugged the
base unit, replace the handset on the base unit for two
to five seconds to reset the system.
Check the handset has been registered (see page 11).
PROBLEM
No power on the
handset
Does not charge
Check the battery pack plug, inside the battery
compartment of the handset, is fully pushed in.
The handset rechargeable Ni-Cad battery pack may need
to be charged.
Check the AC Adaptor is plugged in at both ends and
switched On.
SUGGESTION
Make sure the charging contacts on both the handset and
the base unit are in contact during charging.
The charging contacts may need to be cleaned with a dry
cloth or pencil eraser.
The battery pack may need to be discharged first before
a full charge can be accomplished.
Check the AC Adaptor is plugged in at both ends and
switched On.
Range is limited
Make sure the base antenna is vertical.
Move the base unit so that it is centrally located in your
residence or office and make sure that the base unit is
not located near electrical appliances.
Calls received,
flutter or fade The handset rechargeable battery pack may need
charging.
You may be out of normal operating range. Move closer
Cannot store or
recall phone
numbers from
memory
When storing phone numbers, make sure that the handset
is in the standby position.
When recalling stored numbers, check first for a dial
tone. TR
OUBLESHOOTING