Uniden DRX332 - Manual (Page 3)

3
Setti ng Up Your Handset
Install the Batt ery
1. Unpack the handset, battery pack, and
battery cover. If the battery cover is
already on the handset, press in on
the notch and slide the cover down
and off.
2. Line up the battery pack connector
with the jack inside the handset.
(The battery connector only fits one way.)
3. Push the battery pack connector in until it clicks into place.
Tug gently on the wires to make sure the battery pack is
securely connected.
4. Place the cover over the battery compartment and slide it
up into place.
Connect the Charger
1. Connect the AC adapter to the
charger's
AC IN 6.5V
jack and
route the cord as shown. (This
adapter might already be
connected.)
2. Plug the other end of the
adapter into a standard 120V AC power outlet.
3. Place the handset in the charger with the display facing
forward. The display on the handset should light up; if it
doesn't, reseat the handset or try plugging the AC adapter
into a different outlet.
#
Charge the handset completely (about 15 hours) before using it.