Resetting the handset without the base, Changing the digital security code, Traveling out of range – Uniden DCT736 User Manual

Page 44: Changing.the.digital.security.code, Traveling.out.of.range, Resetting.the.handset.without.the.base

Resetting.the.Handset.without.the.Base

If.your.original.base.is.not.available.for.some.reason.(for.example,.it.is.

lost.or.somehow.incapacitated),.you.can.still.reset.the.handset.and.use.it.

with.another.base..

Press.and.hold.

[ ] and.[#/ ] for.at.least.5.seconds.until.the.

SYSTEM.RESET.menu.appears..
Move.the.cursor.to.select.the.REPLACING.BASE.submenu,.and.

then.press

..REPLACE.BASE.appears.

Move.the.cursor.to.select.YES,.and.then.press.

. A confirmation tone sounds. The handset de-

letes.its.own.base.information.without.trying.to.contact.the.base..When.the.base.information.is.deleted,.the.

handset.displays.MODELS.VARY!

CHARGE.HANDSET.ON.THE.BASE.REGISTRATION.OR.REFER.TO.

OWNER’S.MANUAL.

To.register.the.handset.to.the.new.base,.see.page.1.

Changing.the.Digital.Security.Code

The digital security code is an identification code used to connect the handset and the base unit. Your unit ships from

the.manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.

you.suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.

by.a.manufacturer’s.Call.Center.Representative,.you.can.change.the.code..To.change.the.digital.security.code:

Reset.all.handsets.(see.page.).

Re-register.each.handset.by.following.the.steps.on.page.1.

Traveling.Out.of.Range

During.a.call,.as.you.begin.to.move.your.handset.too.far.from.your.base.unit,.noise.may.increase..If.you.pass.the.

range.limits.of.the.base.unit,.you.hear.a.beep.and.see.OUT.OF.RANGE.on.the.display,.and.then.the.handset.returns.

to.standby..You.may.return.to.the.call.if.you.move.your.handset.within.the.range.limits.of.the.base.and.press.

[ /flash] or.[ ].within.30.seconds.