Uniden XS210 - Manual (Page 6)

5
Battery use time (per charge)
From fully charged
• Up to seven hours continuous use
• Up to fourteen days when the handset is in the standby mode
Low Battery Alert
If the phone is not in use, the
talk/batt low LED flashes when the
battery pack is low.
If the phone is in use, the talk/batt low LED flashes and the handset
beeps. Complete your conversation as quickly as possible and return the
handset to the base for charging.
Cleaning the battery charging contacts
To maintain a good charge, it is
important to clean the charging
contacts on both the handset and
base unit once a month.
Use a dry cloth to clean.
BATTERY MAINTENANCE
For optimum
performance, be sure to
return the handset to
the base unit after each
telephone call.
Use only the Uniden
Battery (BT-905)
supplied with your
phone.
Replacement
batteries are also available
through the Uniden
Parts Department.
• The key
redials the last number
dialed.
• The redialed number can
be up to 24 digits long.
Making and Receiving Calls
Answer call
Make call
Hang up Press or return the handset to the base (Auto Standby).
Redial
Ringer Mute None
Handset Off Base
Press , any number key,
, or .
1) Press .
2) The talk/batt low LED
flashes and turns on.
3) Listen for the dial tone.
4) Dial the number.
1) Press .
2) Listen for the dial tone.
3) Press to dial the
last dialed number.
Press when ringing.
USING YOUR PHONE
Handset On Base
When the phone rings, remove the
handset from the base (Auto Talk).
1) Remove the handset from the
base and press .
2) The talk/batt low LED
flashes and turns on.
3) Listen for the dial tone.
4) Dial the number.
1) Remove the handset from the
base and press .
2) Listen for the dial tone.
3) Press to dial the
last dialed number.
XS210.Qx 10/6/03 5:27 PM Page 6