Uniden XS210 - Manual (Page 10)

9
If your cordless telephone is not performing to your expectations, please try
these simple steps.
TROUBLESHOOTING
Symptom
The status
LED won’t illuminate when
the handset is placed
in the base.
The audio sounds weak
and/or scratchy.
Can’t make or receive
calls.
Handset doesn’t ring or
receive a page.
Severe noise
interference
Your phone has been
exposed to moisture or
liquid
If you still have
a problem
Suggestion
• Make sure the AC adapter is plugged into the base
and a wall outlet.
• Make sure the handset is properly seated in the
base.
• Make sure that the charging contacts on the
handset and on the base are clean.
• Move the handset and/or base to a different
location away from metal objects or appliances
and try again.
• Press to help eliminate background
noise.
• Check both ends of the telephone line cord.
• Make sure the AC adapter is plugged into the base
and a wall outlet.
• Make sure that the base antenna is in the vertical
position.
• Disconnect the AC adapter for a few minutes, then
reconnect it.
• Change the digital security code (See page 8).
• Make sure that the handset is not too far from the
base.
• The battery pack may be weak. Charge the battery
for 15-20 hours.
• The handset may be too far away from the base.
• Place the base away from appliances or metal
objects.
• Change the digital security code (See page 8).
• Keep the handset away from microwave ovens,
computers, remote control toys, wireless
microphones, alarm systems, intercoms, room
monitors, fluorescent lights, and electrical
appliances.
• Move to another location or turn off the source of
interference.
• Return to your local service agent immediately.
• www.uniden.com.au (AUSTRALIA) or
• www.uniden.co.nz (NEW ZEALAND)
Do not attempt to service
this unit yourself. Servicing
must be performed by
qualified personnel.
XS210.Qx 10/6/03 5:27 PM Page 10