Uniden UH-040XR - Manual (Page 12)

Example. CH40 becomes active
If the received signal cease, the unit will wait for at
least 3 seconds for the signal to return, otherwise
scanning resumes.
To skip the active channel, press [MEM] momentarily. Scanning resumes.
To deactivate SCAN, press the [SCAN] or [PTT] .
Note:
1. If SCAN is deactivated while in an active channel, the UH-040XR will stay on that
active channel. If no other channels are active, the UH-040XR will reinstate the
starting channel.
2. Pressing [OS/GS] will switch to Group Scanning.
2. Group Scan (GS) Mode
To use GS Mode Scanning, press the [OS/GS]
key. GS icon appears on the display.
1. When [SCAN] SW is pressed
during Group Scan Mode, SCAN icon will blink
and Group Scan Scanning begins.
2. To deactivate GS scan, press [SCAN] or [PTT] .
Note:
1. If SCAN is deactivated while it is tuned to an active
channel, the UH-040XR will stay on that active
channel. If none of the channels are active, the UH-
040XR will reinstate the Priority channel.
2. If GS Scanning is initiated when there are no
channels programmed in GS memory, an error tone will be heard and scanning
will not start.
3. Pressing [OS/GS] will switch to Open Scanning.
OS/GS
MEM
DUP
SCAN
9