Uniden XS610 - Manual (Page 20)

18
TROUBLESHOOTING
YOUR NEW PHONE
If your XS610 cordless telephone is not performing to your expectations, please try
these simple steps first before calling Uniden customer service.
Caution: Do not attempt to service this until yourself. Servicing must be performed by
qualified personnel.
TROUBLE SHOOTING
Charge light won’t
come on when
handset is placed
in base.
●
Make sure the AC adaptor is plugged into the base and
wall outlet.
●
Make sure the handset is properly seated in base.
●
Make sure the charging contacts on the handset and base
are clean.
PROBLEM
The audio sounds
weak and/or
scratchy.
Can’t make or
receive calls.
The handset
doesn’t ring or
receive a page.
●
Check both ends of the base telephone
line cord.
●
Make sure the AC adaptor is plugged into the base and
wall outlet.
●
Disconnect the AC adaptor for a few minutes, then
reconnect it.
●
Reset security code by placing the handset back on the
base for a few seconds. The status LED will blink
indicating that the phone has been reset.
●
The Nickel-Cadmium battery pack may be weak.
Charge the battery for 15-20 hours.
●
The handset may be too far away from the base.
Place the base away from appliances or metal objects.
●
Place the base away from appliances or metal objects.
●
Reset security code by placing the handset back on the
charging cradle for a few seconds. The status LED will
blink indicating that the phone has been reset.
SUGGESTION
●
Make sure that the base antenna is fully extended in the
vertical position.
●
Interference by other electronics equipment such as TVs.
Computers microwaves etc.
●
You may have gone too far from the base.
●
Press the chan key to search for clearer reception.