Uniden XS610 - Manual (Page 17)

15
Your XS610 phone has 10 memory locations for storing important telephone
numbers.
1. Remove the handset from the base and press
mem . The talk/batt low LED
flashes and you hear a beep.
2. Enter the phone number you want to store (up to 16 digits).
3. Press
mem and enter a number (0-9) on the keypad for the memory location
you want to use.
You hear a long beep and the
talk LED goes out indicating the number has
been stored successfully.
If you select any keys other than 0-9, the handset will beep rapidly (error tone)
and no number will be stored.
Entering a Pause in Memory Dialling
If you would like to use a phone number stored in memory to access voice mail,
for example, you can store a pause in the phone number sequence.
To use this function, follow steps 1 and 2 in “Storing a Number in Memory,”
then press the
pause button on the handset to place a pause in the phone
number sequence.
Follow the remaining steps in the “Storing a Number in Memory” section to
complete the operation.
Dialling a Stored Number
To dial a phone number stored in memory, press
talk , then press mem and the
memory location (0-9). Your phone will dial the stored number.
STORING A NUMBER IN MEMORY
You have 20 seconds after
pressing mem to enter the
number you wish to store.
Otherwise, an error tone will
sound.
Remember, the phone
number you wish to store
cannot have more than 16
digits, including the pause.
(The pause button counts as
one digit.)
If you attempt to dial a
memory location that does
not have a stored number,
the handset will beep rapidly
(error tone) and the phone
will not dial.